What are the selection principles of stamping hardware?

At present, we manufacture a lot of products with molds, and then use the mold to make them, which can improve the production efficiency. Also h**e many friends to inquire about the selection principle of stamping hardware mold?

1, the first thing to consider in the "select stamping hardware mold under" set of punching die, analysis of set square mold for stamping line is 1.5 times the side length is greater than or equal to die, circular die stamping curves analysis to stay inside, the arc diameter is greater than die diameter, if use the die set.

2, can be classified as the outline of basic graphics, the first to die in the library search whether h**e exactly the same as that of the contour, can use a stamping action out of the outline of stamping hardware mold, if you h**e this kind of mould, will ignore the "select stamping hardware mold under" set of stamping hardware mold, directly to the search for stamping metal mould.

3, to the rectangular profile, when the long side is greater than or equal to 1.5 times that of the short side, will automatically search whether there is a consistent with rectangular short edge square stamping hardware mold: the long slot or circular groove to search whether there is a groove width consistent round stamping hardware mold, if has the direct use of the punching die, after more than two steps remain uncertain die, consider using square die or circular die step rushed straight line or arc.

4. If the set of stamping die is not suitable, the system will search for square or circular punch from small to large in the stamping metal mold base, and the line that satisfies the pressing will be greater than or equal to 1.5 times of the edge length of the punch.

Above 4 points is about the **osing principle of stamping hardware mold and everybody simple i**oduction here, hope to later **ose stamping hardware mold has certain help, to be able to **ose their suitable mould.